Plankton
Jeeper
1% evil, 99% hot gas
Posts: 949
|
Post by Plankton on Mar 30, 2009 18:59:31 GMT -4
got a drain on the tank? using hardline off the compressor output? heat resistant something? Tank has a drain, but the fittings were on the opposite side, so pointing the drain down would point the fittings at the floor of the Jeep. In the short term, I'll un-bolt the tank and curse to drain it. Long term, I'll probably take you up on your offer to weld in a drain. All of the plumbing is being handled by someone else once I have all the components installed. Already discussed using stainless or something that will dissipate heat for the first foot or so before getting into any of the other components.
|
|
Plankton
Jeeper
1% evil, 99% hot gas
Posts: 949
|
Post by Plankton on May 2, 2009 22:38:00 GMT -4
BTT. Finally had an opportunity to install the rest of the parts. Updated my original post with photos and descriptions.
|
|
Jeep3m
Jeeper
I loved my Jeep until I got a Toyota!
Posts: 126
|
Post by Jeep3m on May 13, 2009 9:05:44 GMT -4
Very cool......
|
|
'Roach
Elite
InsurJeeper
...the man who decided to use torx on Jeeps should be beaten severely...
Posts: 1,002,222
|
Post by 'Roach on May 14, 2009 8:15:32 GMT -4
Nice job, very clean install I'm not sure on the outlet on the front of the bumper tho. Doesn't that open it up to trail damage?
|
|
Plankton
Jeeper
1% evil, 99% hot gas
Posts: 949
|
Post by Plankton on May 15, 2009 20:49:58 GMT -4
I've been successful only driving into things so far, so I'm hoping the outlet will be Ok on the rear bumper. Considering putting an outlet in the front, either under the hood, or accessible through the grille slots.
|
|
Hawkes
Hardcore
Lurker
Posts: 5,404
|
Post by Hawkes on May 15, 2009 21:45:15 GMT -4
I've been successful only driving into things so far, so I'm hoping the outlet will be Ok on the rear bumper. Considering putting an outlet in the front, either under the hood, or accessible through the grille slots. You're doing it wrong, you're supposed to bounce off stuff in every direction. Come with me I'll show ya...
|
|
|
Post by theonlybull on May 15, 2009 22:12:13 GMT -4
looks good, but i wouldn't run that coupler stuck outta the bumper like that...... i'd beat it off parking by brale
|
|
The Garagemahal
Moderator
Build Thread King
Resident Army Ranger , Navy Seal , Super-Warrior , Ninja !!
Posts: 11,518
|
Post by The Garagemahal on Feb 23, 2014 21:20:28 GMT -4
Add to jeep fab please
|
|
JoeP
Wheeler
Posts: 25
|
Post by JoeP on Mar 23, 2014 8:03:20 GMT -4
Just food for thought, you can get a very small, totally sealed pressure switch, locally for about $35. link They are preset cut in, cut out. I have used one on my race bike for a few years now. Very tolerant of heat and vibration. Link won't work, here is a pic thorbros.com/catalog/air-management/pressure-switches
|
|