Hawkes
Hardcore
Lurker
Posts: 5,404
|
Post by Hawkes on May 24, 2012 14:12:21 GMT -4
gassed it up today, ready......I think.
Don't forget to lube the hi-lift/farm jack!
|
|
dan
Jeeper
Membership Co-ord - Valley
Posts: 3,397
|
Post by dan on May 24, 2012 16:56:20 GMT -4
have-to-do's for the YJ: -weld on a d-ring to the front -weld in my winch fairlead plate, and bolt my fairlead on -replace 2 u-joints in the rear drive-shaft -Fozzy front spider gears -drain/check all important fluids, change oil maybe
Like-to-do for the YJ: -build oil pan skid -build new exhaust from header to cat
have-to-do's for Dad's TJ: -1.25" BL -1" MML -install 33's -install CB and wire it up -install front lockright -install trans cooler -check all vital fluids/replace if needed
Like-to-do's for Dad's TJ: -install SYE and get rear d-shaft built and u-joints replaced.
2 weeks to go! should have time for the big stuff on the lists anyways
|
|
|
Post by itsakeeper on May 24, 2012 19:32:39 GMT -4
"Don't forget to lube the hi-lift/farm jack! "
Good one, will do the same.
|
|
Jeepy
Jeeper
Posts: 1,216
|
Post by Jeepy on May 24, 2012 19:46:33 GMT -4
Farm jack! Gasp, I thought that word was prohibited from here Hmmm, I need to re seal the rear end cover as it's puking gear oil. Also have a mystery gear oil leak near the t/c. Might get the new meats thrown on the spare wheels and chuck them on.
|
|
BILL
Jeeper
Posts: 3,029
|
Post by BILL on May 24, 2012 20:11:33 GMT -4
this weekend new front yoke and seal rear bumper with swing out tire carrir and a check over. Maybe even rebuild the 8274 and mount it back up
|
|
Hawkes
Hardcore
Lurker
Posts: 5,404
|
Post by Hawkes on May 24, 2012 20:36:23 GMT -4
|
|
|
Post by SocialWheeler on May 25, 2012 4:55:25 GMT -4
Might get the new meats thrown on the spare wheels and chuck them on. What did you get?
|
|
Jeepy
Jeeper
Posts: 1,216
|
Post by Jeepy on May 25, 2012 16:45:06 GMT -4
39.5" Krawlers
|
|
|
Post by itsakeeper on May 25, 2012 19:22:08 GMT -4
excellent !!
|
|
iwonajeep
Jeeper
Jeepin is tasty says Buddy
Posts: 961
|
Post by iwonajeep on May 25, 2012 20:00:19 GMT -4
Show up on time
|
|
dan
Jeeper
Membership Co-ord - Valley
Posts: 3,397
|
Post by dan on May 25, 2012 20:35:12 GMT -4
I'd say that is less likely to happen than for me to finish my lists....
|
|
littlemulticoloredwagoneer
Moderator
Trail Master/Jam Co-chair - Valley
Buy it, Build it, Break it!!...........REPETE!
Posts: 2,310
|
Post by littlemulticoloredwagoneer on May 26, 2012 13:50:01 GMT -4
oh my tummy hurts!! that was funny Peck!
|
|
BILL
Jeeper
Posts: 3,029
|
Post by BILL on May 26, 2012 17:31:53 GMT -4
pack it up with stuff and drive it to the camp ground
|
|
Jeepy
Jeeper
Posts: 1,216
|
Post by Jeepy on May 26, 2012 20:25:35 GMT -4
I had a bigger to do list for my car trailer, repack/replace bearings, paint, undercoat, make new ramps. Jeep got jealous and promptly made the OBA crap out.
|
|
badwithcomputer
Jeeper
You have DC2's? You just made a new best friend.
Posts: 2,863
|
Post by badwithcomputer on May 28, 2012 9:04:23 GMT -4
I've written my list down on countless pieces of paper and I end up losing them, here's hoping I don't forget I wrote it here.
ball joints or wheel bearings? rotate tires
grease the 87 grease nipples under my Jeep change oil check tcase, power steering, diff fluids. finish welding frame holes 2 skid plate bolts maybe degrease the engine, just because. new vanilla air freshener to make the drive down slightly more pleasant.
|
|