|
Post by blacksheepxj on Jun 4, 2010 21:34:00 GMT -4
Replaced front pads and painted front rims. They look a lot better. Just have to paint the rear.
And Enos was right. I was pushing my luck. I discovered I need 2 front hub assy. They are not that bad yet so it will wait until after Jam.
Rob
|
|
|
Post by T-Dogg on Jun 4, 2010 21:34:38 GMT -4
Fliped carier bearing's,(thank's Jan for looking @ it for me). Closed up diff,front end all put togather again.Replaced both battery cabel conectors.Looked @ rock rails and said, them tires are heaver with sore rib's and shoulder,,,that can wait,,,,,Get'n excited DA Dogg
|
|
|
Post by Johnniemac on Jun 4, 2010 22:28:42 GMT -4
New ujoints in RR drive shaft and one in the front axle, RR R&P is installed, leaking fuel line replaced. Still need to tuck muffler higher, FT wheel bearing, mount gas tank and get the 4:11's in the front - few more sleeps *giggity*
|
|
maddog
Jeeper
NAVY
Posts: 1,063
|
Post by maddog on Jun 5, 2010 1:06:27 GMT -4
Its ALIVE, got Repete fuel injection system set up on the waggy. should be able to see if i can brake something tomorrow. stillm got lot more to do. shake down tonight, well its broke. i need to swap tranny tomorrow, i blew the front seal and lost a cap onthe front axle. better now then friday
|
|
maddog
Jeeper
NAVY
Posts: 1,063
|
Post by maddog on Jun 5, 2010 1:13:07 GMT -4
Its ALIVE, got Repete fuel injection system set up on the waggy. should be able to see if i can brake something tomorrow. stillm got lot more to do. shake down tonight, well its broke. i need to swap tranny tomorrow, i blew the front seal. i don't feel so bad, my friend Tom had to leave his truck in the wood.
|
|
kilo69
Jeeper
Coldstream Explorer
Posts: 1,528
|
Post by kilo69 on Jun 5, 2010 10:31:48 GMT -4
Well I tore into the front end this morning and found the following: Pinion bearings (Why are started prepping my spare D30) Both upper ball joints on either side Driver's side wheel bearing Driver's side caliper is seized shimmy shock is half gone tie-rod bent in the center
Luckily I bought that burnt YJ for $50 and it's front axle has everything good except for the driver's side U-joint. Axle swap in full swing now... just switched out the bad U-joint with my spare shaft and found a nice shiny wheel unit bearing under all the dirt! Best $50 I ever spent!
|
|
|
Post by Ken McIntosh on Jun 5, 2010 13:05:54 GMT -4
Mostly ready , still have to swap the rock rails from the 95 .Also hook up the cb ,I have a walkie talkie stye one if I don't get to it.Also would like to hook my inverter back up but no biggie if I don't.Probably will install fozzied side gears for the weekend.Getting pretty pumped. ;D
|
|
|
Post by blacksheepxj on Jun 5, 2010 14:11:24 GMT -4
All done. Just have to load spare parts and camping stuff. The XJ is even all fueled up.
Rob
|
|
|
Post by Apexed on Jun 5, 2010 15:16:20 GMT -4
Pin replacement in the rear locker and pump/sending unit(dis-assembly damage....). All do-able if I were not working in CB this week.....
|
|
The Garagemahal
Moderator
Build Thread King
Resident Army Ranger , Navy Seal , Super-Warrior , Ninja !!
Posts: 11,518
|
Post by The Garagemahal on Jun 5, 2010 16:25:58 GMT -4
Stevens teaser pic
|
|
justajeep
Moderator
Valley - VP
Bear River, NS
Posts: 7,214
|
Post by justajeep on Jun 5, 2010 18:37:31 GMT -4
Built 90% of my back bumper today.
|
|
jjcan
Jeeper
Posts: 1,424
|
Post by jjcan on Jun 5, 2010 19:53:00 GMT -4
I'll buy some gas tomorrow
John
|
|
shadow
Hardcore
Age and Experience will trump Youth and Exuberance anyday...;)
Posts: 6,997
|
Post by shadow on Jun 5, 2010 20:29:09 GMT -4
I'll buy some gas tomorrow John LMAO...you must have done all your preparing before the Landrover run did ya John... ;D
|
|
justajeep
Moderator
Valley - VP
Bear River, NS
Posts: 7,214
|
Post by justajeep on Jun 6, 2010 20:33:15 GMT -4
Went over to Enos' to pick up our sleeping accommodations and discovered I need to get my new rad in for towing.
ZJ heaters do a great job of cooling the engine, but they put out a lot of heat doing it!!
|
|
Enos
Hardcore
Founding Member
Posts: 8,513
|
Post by Enos on Jun 6, 2010 20:37:04 GMT -4
Went over to Enos' to pick up our sleeping accommodations and discovered I need to get my new rad in for towing. ZJ heaters do a great job of cooling the engine, but they put out a lot of heat doing it!! Whoops
|
|