BILL
Jeeper
Posts: 3,029
|
Post by BILL on Apr 29, 2011 7:06:25 GMT -4
My list is now RC long arms BDS 4.5 inch springs Zone 1.25 inch BL RC mm lift Rugged Ridge Slip Yoke Elimator Extended brake lines and maybe a rear locker Hmmm can we say SHOW OFF,,, You got all that coin hook a britha up with a locker,,Ill hook ya up l8r Cant wait to guide you over the rock garden,,, ;D Ooooo you should add new mirrors to that order Da Dogg I wont need mirrors with no doors on haha i knew youwould make a comment like that haha you wait
|
|
Missbehavin
Jeeper
Membership Coord/Secretary - Halifax
ladies run in a few days, hopefully the weather stays as currently predicted!
Posts: 1,187
|
Post by Missbehavin on Apr 29, 2011 14:23:27 GMT -4
my to do list is..... ---install gas tank skid ---remove seats etc and add more rubber to my floor ;D ---alignment ---topping up fluids.... Thats all for now
|
|
lowridin
Jeeper
possibilities are "unlimited"
Posts: 253
|
Post by lowridin on Apr 29, 2011 14:47:08 GMT -4
My to do list -new disconnects - Installed May 1st -calibrate deflators -tried huge fail - Waiting upgraded set -get the water on and general clean up at the cottage (lake george has the best accomadations I can get for Jam)
allan's to do (justsbuilt) -modify winch plate for 8274 -rock rails for LJ
|
|
jptj
Jeeper
Trail Master - Valley
Posts: 879
|
Post by jptj on Apr 29, 2011 22:14:59 GMT -4
Crazy French get you too, Dave? ;D
|
|
jmurphy
Jeeper
Trail Master 2 - Valley
Posts: 994
|
Post by jmurphy on Apr 30, 2011 7:55:56 GMT -4
Mine is: -Repaint rock rails -Finish flat belly skid -Replace lower control arm bushings -Replace tran mount -Re-work rear bumper/tire carrier (if there is time)
|
|
|
Post by George of the Jungle on Apr 30, 2011 12:11:35 GMT -4
Mine is: -Repaint rock rails -Finish flat belly skid -Replace lower control arm bushings -Replace tran mount -Re-work rear bumper/tire carrier (if there is time) Frame ???or have you already fixed it .
|
|
jmurphy
Jeeper
Trail Master 2 - Valley
Posts: 994
|
Post by jmurphy on Apr 30, 2011 14:44:04 GMT -4
Frame ???or have you already fixed it . That's on the "after Jam" list! The Jeep rolls into the workshop on June 13th and rolls out with frame repaired, long arms and other fun stuff sometime in July (or August...).
|
|
|
Post by Cherokee Chief on May 1, 2011 19:42:35 GMT -4
repair front end. find some more axleshafts investagate if I broke my front locker or not (hopefully not) Darren
|
|
Missbehavin
Jeeper
Membership Coord/Secretary - Halifax
ladies run in a few days, hopefully the weather stays as currently predicted!
Posts: 1,187
|
Post by Missbehavin on May 31, 2011 7:04:27 GMT -4
halfway threw my list....i went to carwash sunday and pressure washed the inside on Missb took all seats etc out...lol was funny oh and fun!!!! gas tank skid is almost on, just to pour some more rubber on the floor and plug my new drain holes...then its fluid top ups and an alignment....then start packing her all back up again ;D
|
|
|
Post by havnfun on Jun 4, 2011 7:37:24 GMT -4
I guess i better start building something
|
|
Stevens
Jeeper
2008 Mud Pit Master
Posts: 3,240
|
Post by Stevens on Jun 4, 2011 8:27:38 GMT -4
My list still looks as big as it did 6 months ago! ;D
|
|
Hawkes
Hardcore
Lurker
Posts: 5,404
|
Post by Hawkes on Jun 4, 2011 10:54:35 GMT -4
My list still looks as big as it did 6 months ago! ;D If you've got a forward gear and a reverse gear you're good to go. 2 wheel drive would put you down with the rest of us, at least when you had the boggers.
|
|
Stevens
Jeeper
2008 Mud Pit Master
Posts: 3,240
|
Post by Stevens on Jun 4, 2011 11:25:37 GMT -4
Haha, I had no 4 low when I was shaking it down.....and with the 3.55's and auto in 4 hi I couldn't get over a 12" ledge without bumping it!! ugggg lol
|
|
beth
Jeeper
Bouncy & fun
Posts: 1,398
|
Post by beth on Jun 4, 2011 14:29:59 GMT -4
I guess i better start building something Yeah you should!
|
|
Big G
Hardcore
Posts: 5,146
|
Post by Big G on Jun 4, 2011 15:08:52 GMT -4
Have to; -change rear diff oil (cover's leaking) Want to; -mount Warn compressor behind rear seat... this will require longer wires, and the switch to be mounted up front -get rear long arms -get independent tranny cooler installed -fan shroud made and installed -wash & wax Not alot really (not that it'll all get done)... got 'er ship shape for the Canoe Trip, so the big list's been done. Well, other then wash and wax, none of the wants are getting done. I still have to do the rear diff, change one hub and pack wheel bearings, and grease front CV (remove & re-instal) Turtle Wax Ice ROCKS!!!
|
|