|
|
Post by RECOVERY#1 on Jun 11, 2012 11:03:25 GMT -4
The only damage this jam is a 2'' dent on my drivers side rocker panel.  Bennett |
|
newbiejeeper
Jeeper
YOU, a published writer?..Internet don?t count. Any asshole can throw shit up on there
Posts: 2,494
|
Post by newbiejeeper on Jun 11, 2012 11:04:00 GMT -4
My liver... that can make this carnage report right ??
|
|
Missbehavin
Jeeper
Membership Coord/Secretary - Halifax
ladies run in a few days, hopefully the weather stays as currently predicted!
Posts: 1,187
|
Post by Missbehavin on Jun 11, 2012 11:31:51 GMT -4
Need to replace some exhaust pipe, its currently only there because of wire and hose clamps, headlights is being held in with electrical tape and doesn't work because the wire broke off the connector, my engine mounts or frame is flexing I can only run my auxiliary fan at certain times or it grinds, on the trip home after we stopped for breakfast missb wouldn't start, stevens, Brent and Kevin frigged around with a bunch of stuff, there was a blown fuse... She ended up starting but I had no gauges so flew home as fast as I could! I think this was missb's last jam! Sad sad!! Starting to look for another project.... Not happy but think its got to be done!
|
|
The Garagemahal
Moderator 
Build Thread King
Resident Army Ranger , Navy Seal , Super-Warrior , Ninja !!
Posts: 11,518
|
Post by The Garagemahal on Jun 11, 2012 11:36:49 GMT -4
My liver... that can make this carnage report right ?? Lol. I didn't know you were there Jon , I would have had a beer with you. I have almost completely lost my voice , my liver is prob in the same boat as everyone else's |
|
Hawkes
Hardcore
Lurker
Posts: 5,404
|
Post by Hawkes on Jun 11, 2012 12:27:14 GMT -4
Couple dents.
|
|
Big G
Hardcore
Posts: 5,146
|
Post by Big G on Jun 11, 2012 12:33:05 GMT -4
ARB line to the front let go... I suppose it could be the O rings, but not likely. Haven't looked at it yet.
Decent dent in the pass side of the hood coming out of the bowl on Crandfield's.
Not too bad. Krawlers blew me away on the rocks. Just spent a couple hours washing her, and unpacking. Best thing I do at Jam is take monday off.
|
|
|
|
Post by T-Dogg on Jun 11, 2012 13:21:36 GMT -4
Rear pinion bearing let go on Sat  Thanks for the help tightening it up Jan. Will need replaceing maybe a new rear end if the pinion bearing melted onto the shaft,,,  Mild Jam for Da Dogg ;D Da Dogg |
|
|
|
Post by itsakeeper on Jun 11, 2012 13:51:16 GMT -4
ARB line to the front let go... I suppose it could be the O rings, but not likely. Haven't looked at it yet. Decent dent in the pass side of the hood coming out of the bowl on Crandfield's. Not too bad. Krawlers blew me away on the rocks. Just spent a couple hours washing her, and unpacking. Best thing I do at Jam is take monday off. How were they in the mud ? |
|
coolwind1
Moderator
President - Halifax Chapter
Posts: 1,318
|
Post by coolwind1 on Jun 11, 2012 14:07:07 GMT -4
Bent the tie rod in several directions, sheered the lower slider bolt off the caliper.......and thats pretty much it.
|
|
sickpuppy
N
Everything I ride, gets put away wet and dirty!
Posts: 20
|
Post by sickpuppy on Jun 11, 2012 14:13:33 GMT -4
blew a front drivers axle friday. and a few dents in the under armor. twisted and bent the rear driveshaft on the rock pile. had a buddy come up with a miller welder and 40' trailer. cut and welded up a new driveshaft sat morning on the picnic table in the rain lol. saturday was mostly just body damage for me. front right and left box sides are stoved in pretty good. cab corner took a good one tailgates got a small dent. everything else did it's job for protection lol. and I blew a tire off the rim. once home the post trip inspection was mostly all good machanically. I'm happy with her.
Chad
|
|
Old Yeller
Jeeper
Its... sitting next to my garage. Poor girl.
Posts: 2,890
|
Post by Old Yeller on Jun 11, 2012 14:54:07 GMT -4
After pressure washing my jeep underneath, I had to rake, and then shovel nearly a full wheel barrow load of mud and grass clumps from the lawn. A bunch of John Cranfields land finds its way home with me every time lol.
Still needs a more thorough cleaning, then inspecting to find any hidden damage, but I can put it away for a bit before tackling my next big project. Passing another mvi! lol.
Rob D
|
|
Muddin Mar
Moderator
Jam Co-Chair
featuring Black Betty (aka Mini Beast)
Posts: 913
|
Post by Muddin Mar on Jun 11, 2012 15:40:03 GMT -4
So far I know I need a trac bar bushing/bolt, tierod end(pitman arm), need to tighten up my tail pipe...I still have to go wash it and then give her a good check over .... there maybe more than I don't know of yet lol... I had to replace my electric fan Fri night at Jam, (thank you Andre for bringing me another one)....so that's what I know for now anyway  |
|
|
|
Post by greg09wr on Jun 11, 2012 16:41:34 GMT -4
I bent the side of my tub in behind the door, blew a hub, tweeked my windshield frame and on the way home i also lost a tire... Bearing blew and spit out the rear tire and axle on the highway. Lucky for me i pulled over just in time, the race was still intact and it didnt chew up my locker. Just jacked it up threw a spare axle in and i was back on my way home
|
|
|
|
Post by superkev on Jun 11, 2012 17:03:12 GMT -4
I rebroke my pass side mirror that I broke on Tia's last year comming out of the bowl on cranfields
|
|
Jeepy
Jeeper
Posts: 1,216
|
Post by Jeepy on Jun 11, 2012 17:12:07 GMT -4
Put a dent in the tranny pan, did a little body re-arranging ( looks like the Krawlers are larger than Iroks!)
Exhaust is a bit louder but that seems to be it.
|
|
