|
Post by Mickey on Jul 22, 2014 21:32:21 GMT -4
What is the largest size tires that will fit on a 96-97 grand Cherokee with a 4' BDS lift kit?
Mickey
|
|
dan
Jeeper
Membership Co-ord - Valley
Posts: 3,397
|
Post by dan on Jul 23, 2014 5:00:09 GMT -4
with or without trimming wheel-wells?
|
|
mrg
Jeeper
Steering Committee - Halifax
Posts: 2,705
|
Post by mrg on Jul 23, 2014 8:32:50 GMT -4
I put 235-85-16 GoodYear Duratracs on my stock wheels with my 4" lift. The lift came with extended bump stops front and rear. I also have slightly longer lower control arms front and rear. About 1" longer than stock. The only trimming I did was a very small amount off the front bumper as the tire looked like it might hit it when turning. I have a small amount of rubbing on the lower control arm at full lock. The rear tire hit the exhaust pipe but I just bent that out of the way. I have no other rubbing but have not disconnected yet.
|
|
|
Post by rtdj on Jul 24, 2014 11:56:57 GMT -4
I have a 4" rc long arm and 2" spring lift kit and I have 285/75/16 on mine with 1.5 wheel spacers.no cutting.
|
|
|
Post by derekmac on Jul 24, 2014 14:14:36 GMT -4
I have a 4" rc long arm and 2" spring lift kit and I have 285/75/16 on mine with 1.5 wheel spacers.no cutting. Careful if you are going to wheel with that size. Here are 245/70-17's, and there's little to no room to spare. If my front bumper wasn't cut, the tire would be into it.
|
|
|
Post by Mickey on Jul 25, 2014 20:43:51 GMT -4
wow that is a tight fit
Mickey
|
|
The Garagemahal
Moderator
Build Thread King
Resident Army Ranger , Navy Seal , Super-Warrior , Ninja !!
Posts: 11,518
|
Post by The Garagemahal on Jul 25, 2014 21:15:06 GMT -4
Wrong jeep tho Mickey , Derek has a 02 WJ not a ZJ I can make fit what ever size tire you want on there
|
|
|
Post by derekmac on Jul 25, 2014 21:27:59 GMT -4
Yeah, sorry Mickey, I just wanted to show rtdj how tight the wheel wells are on our WJ's if not trimmed.
|
|
|
Post by rtdj on Jul 30, 2014 17:59:49 GMT -4
Sorry guys went to turn out of my driveway and couldn't turn the corner.had to cut a little on the bottom front bumper ( 10cm ) and cut the front back fender like the way u put bushwacker flares on 2" back and the inner lip seem had to be cut.285/75/16 4" offset
|
|