jmurphy
Jeeper
Trail Master 2 - Valley
Posts: 994
|
Post by jmurphy on Sept 5, 2014 21:34:26 GMT -4
Looking for dana 44 flat top knuckles, spindles and caliper brackets from a mid 70s Chev K10 or K15.
Thanks
Jonathan
|
|
|
|
Post by mudandmore on Sept 5, 2014 22:16:08 GMT -4
I have a REID racing knuckle for the drivers side, only out of the box to look at... 275.00
Cost me over 300 shipped from the USA...
|
|
Creepy
Administrator 
Dartmouth
Posts: 18,718
|
Post by Creepy on Sept 6, 2014 10:27:14 GMT -4
I have some from a 3/4ton Chev D44. Its 8-bolt wheel hubs tho.
Axle tubes were cut off, have inner C's, knuckles, spindles, 8bolt wheel hubs. Can't recall spindle bolt pattern right off. Want me to go look and price 'em?
Can get you a pic if interested.
Not sure on caliper brackets.
|
|
jmurphy
Jeeper
Trail Master 2 - Valley
Posts: 994
|
Post by jmurphy on Sept 6, 2014 12:34:31 GMT -4
I have some from a 3/4ton Chev D44. Its 8-bolt wheel hubs tho. Axle tubes were cut off, have inner C's, knuckles, spindles, 8bolt wheel hubs. Can't recall spindle bolt pattern right off. Want me to go look and price 'em? Can get you a pic if interested. Not sure on caliper brackets. Edit: Yes. Please price. Sent you a PM. Pic of the pass knuckle, please. |
|
Creepy
Administrator
Dartmouth
Posts: 18,718
|
Post by Creepy on Sept 6, 2014 12:58:31 GMT -4
I'm gone dragging home a CJ, remind me if I forget. prob won't get to it today.
|
|
