Creepy
Administrator
Dartmouth
Posts: 18,718
|
Post by Creepy on May 11, 2011 1:27:48 GMT -4
Got to try out running sheet aluminum on the plasma table. It's 16G (.060"). Feedrate 175 inches per minute, 45Amps, 110Volts. Made a sign. T&S for Lance's place of employment. test cuts in the lower left corner. I make those to get the cutting parameters dialed in. Had some left over, so I continued to 'toolprove' and fooled around with small holes at the high feedrate, and then some lettering. Check out that hole. I have a purpose for this peice, see camper thread....I screwed up the outside dims of this one, so I hung it on the box fan.
|
|
littlemulticoloredwagoneer
Moderator
Trail Master/Jam Co-chair - Valley
Buy it, Build it, Break it!!...........REPETE!
Posts: 2,310
|
Post by littlemulticoloredwagoneer on May 22, 2011 16:07:56 GMT -4
Jan you did an Awesome job, Brad could not be happier.. will post pics soon when it's mounted!
|
|
Creepy
Administrator
Dartmouth
Posts: 18,718
|
Post by Creepy on May 22, 2011 20:44:11 GMT -4
Great. I've never done any sign work. He said he was covering it with vinyl?
|
|